Built-in multiple fast charge protocol
ITECH IT8511G+ with the optional IT-E164 module has 8 fast charging protocols built in, meeting the test requirement of fast charging adapters, power banks, fast charging power banks and other products. At the same time, it also has other functions like automatic testing, battery discharge testing, dynamic testing, etc. So it can complete most of the performance testing of switching power supplies, batteries and other product during the development and production stages.
Voltage/current ripple measurement
Ripple is one of the parameters that must be tested for switching power supplies. Excessive ripple may cause interference to the DUT or shorten the life of the DUT. ITECH IT8511G+ has a ripple measurement function, and its measurement bandwidth is up to 300kHz, which meets the ripple measurement requirements of switching power supplies or chargers. At the same time, its remote sense function can help to eliminate the impact caused by the voltage drop on the line. No oscilloscope needed, users can just press the ‘down’ button on the front panel to read the voltage ripple value (Vpp/Vp+/Vp-) and current ripple value (Ipp/Ip+/Ip-) of the DUT directly. This greatly simplifies the wiring and operation process.
Key Features and Functions
- Maximum power 150 W
- Voltage: 0.1-150 V
- Current: 0-30 A
- USB interface
- 7 operating modes: ?CC/CV/CR/CW/CR+CC/CV+CC/CR-LED
- Ripple measurement
- Built in 8 fast charging communication protocol, including QC2.0,
- QC3.0, PE+, PE2.0+, USB PD2.0, USB,PD3.0, FCP, SCP
- Requires Fast charge card IT-E164
- Dynamic mode up to 20kHz
- Voltage measurement resolution up to 0.1mV / 0.1mA
- OPP/OCP test functions
- Battery discharge mode
- Automatic test functions
- List/dynamic mode
- Current monitoring
- Short circuit / Measure function
Key Specifications
DC Input Ratings:
- Power: 150 W
- Resolution: 10 mW
- Voltage: 0.1-18/0.1-150 V
- Resolution: 1 mV/10 mV
- Current: 0-3 A and 0-30 A
- Resolution: 0.1 mA/1 mA
- Resistance: 0.05-10 Ohm/10 Ohm to 7.5 kOhm
Operating modes:
- Static Mode
- Constant Voltage
- Constant Current
- Constant Resistance
- Constant Power
- CR+CC
- CV+CC
- CR-LED
- Dynamic Mode
- Continous Transient
- Pulsed transient
- Toggled transient
- List Mode
Setup Accuracy:
- Voltage: (0.05%+0.025% Full Scale)
- Current: (0.05%+0.05% Full Scale)
- Resistance: (0.01%+0.08 S)/(0.01%+0.0008 S)
- Power: 0.1%+0.2% Full Scale
